（1）管路要尽量避开高温辐射及冷却水喷淋等温度太高或太低之处，特别是胶管接头；
(1) try to avoid high or low temperature places such as high temperature radiation and cooling water spray, especially rubber pipe joints;
（2）布管应不影响主机等设备运转，要安全可靠，方便工作、观察、维修；
(2) the pipe laying shall not affect the operation of the main machine and other equipment, and shall be safe and reliable, convenient for work, observation and maintenance;
（3）布管要横平竖直、整齐美观。尽量少拐弯或小角度弯管，采用大圆弧，从而减少油流阻力；
(3) the pipe layout shall be horizontal, vertical, neat and beautiful. Reduce bends or small angle bends as much as possible, and adopt large arc to reduce oil flow resistance;
(4）安装发生抵触时，应小管让大管、低压管让高压管；
(4) in case of conflict in installation, small pipes shall be used to let large pipes and low-pressure pipes to let high-pressure pipes;
（5） 管道在相互交叉时不能接触，应隔开一定距离；
(5) the pipelines shall not contact each other when crossing, and shall be separated by a certain distance;
（6） 平行管道的接头要错开安装，以免影响安装和拆卸；
(6) the joints of parallel pipes shall be installed staggered to avoid affecting the installation and disassembly;
（7）管道为便于拆卸清洗，应适当安装活接头，但要少用，减少泄漏的可能性。
(7) in order to facilitate disassembly and cleaning of pipes, flexible joints shall be properly installed, but less shall be used to reduce the possibility of leakage.