泉州通风管道诚信加工厂

1、不要用手检查是否泄漏，液压油温度经常会达到150°F甚至更高，能迅速造成严重烧伤。此外，用手接触高流速针眼泄漏流体可能带来灾难性的后果。

1, do not use the hand to check whether leakage, hydraulic oil temperature can often reach 150 F or even higher, can quickly cause serious burns. In addition, the leakage of fluid may have disastrous consequences to touch high speed needle.

2、不要仅通过拧紧螺母就试图解决泄露问题，只有少数情况，液体泄漏时因螺母松动造成的，过度拧紧会破坏接头的完整性，是导致接头泄漏的常见原因之一。

2, do not attempt to solve the leakage problem only by tightening the nut. Only a few cases, excessive tightening of the nut due to loosening of the nut due to loosening of the liquid will cause damage to the integrity of the joints, which is one of the common causes of the leakage of the joints.

3、不要带压检查系统，在进行检查之前，请务必给系统泄压，即使液体滴露缓慢也应该这样做，释放压力能最大限度减小机械部件在检查时突发液压油喷射的风险。

3, don't bring pressure to check the system prior to inspection, please be sure to give the system pressure relief, even if the droplets should do so slowly, the release of pressure can minimize the risk of mechanical components in the hydraulic oil jet burst check when.

4、不要更换不同类型的接头来节省时间/成本，确保更换完全相同类型的接头，随意找一个类似的接头替换，是导致故障的原因之一。

4, do not replace different types of joints to save time / cost, ensure that the same type of joint is replaced, and find a similar replacement at random, which is one of the reasons for the failure.

5、不要总是怀疑接头，滴油点可能不是泄漏点，液体滴落发生在最低点，虽然液体可能在接头位置滴落，但是实际泄漏点可能在其它部位。

5, do not always suspect the connector. The drip point may not be the leakage point. The liquid drop occurs at the lowest point. Though the liquid may drop at the joint position, the actual leakage point may be elsewhere.

6、不要重复使用O形圈，在重复装配可重复使用的接头时，应该及时更换O形圈，O形圈很容易产生裂纹，从而可能在重复装配时破坏系统的密封性能。

6, do not repeat the use of the O shaped ring. When reassembling the reusable joint, the O ring should be replaced in time. The O ring will easily cause cracks, which may damage the sealing performance of the system during repeated assembly.